Ultra chef UC275 Benutzerhandbuch Seite 18

INSTRUCTIONS FOR USE
Please follow these instructions carefully. Failure to do so could result in serious damage to your
barbecue as well as injury to you and your property.
1. Assemble the barbecue following the assembly instructions carefully.
2. Connect the gas hose to the barbecue. Connect the regulator to the hose.
3. Connect the regulator to the cylinder valve following the regulator instructions supplied with
the regulator.
4. Turn all the control knobs to the "OFF" position before turning on the gas supply to the
appliance.
5. Operate the regulator in accordance with the instructions supplied with the regulator.
LIGHTING YOUR BARBECUE
1. Connect the gas cylinder to the barbecue following the instructions supplied with the
regulator.
2. Turn all the control knobs to the "OFF" position.
3. Turn "ON" the gas supply at the cylinder or regulator switch following the regulator
connection and operating instructions. Check for leakage at the cylinder to regulator
connection and hose to barbecue hose inlet connection using soapy water. Any leakage will
appear as bubbles in the area of the leak. If a leak is found, do not use the barbecue.
Contact your gas or barbecue supplier for advice.
4. To light the left-hand burner, push down and turn the left-hand burner control knob anti-
clockwise to the 90° position (full rate position). An audible click will be heard; this should
light the burner. Check that the burner is correctly lit. If the burner has not lit, repeat this
process.
5. If the burner has not lit after two attempts, turn "OFF" the gas tap and wait 5 minutes before
retrying the ignition sequence.
6. When the burner has lit, the burner rate can be adjusted by turning the knob anti-clockwise to
any position between the full and low rate positions.
7. To light the right-hand burner, push down and turn the right-hand burner control knob anti-
clockwise to the 90° position (full rate position). An audible click will be heard; this should
light the burner. Check that the burner is correctly lit. If the burner has not lit, repeat this
process.
8. When the burner has lit, the burner rate can be adjusted by turning the knob anti-clockwise to
any position between the full and low rate positions.
9. To turn "OFF" the barbecue, turn the cylinder valve handle or regulator switch to the "OFF"
position by following the regulator instructions. Once the burners have extinguished, turn all
the control knobs to the "OFF" position.
Warning: If any burner fails to ignite, turn the control knob as well as the cylinder valve to the
"OFF" position (clockwise). Wait five minutes before attempting to relight with ignition
sequence.
After use, close the gas supply by either turning "OFF" the switch on the regulator or turning
"OFF" the cylinder valve.
In the event of flashback while the appliance is in use, turn all the controls, cylinder valve, and
regulator switch to the "OFF" position. Wait 5 minutes before attempting to relight the appliance.
If the problem persists after relighting, contact your gas dealer, the store where you purchased
the barbecue, or a qualified gas engineer for assistance or repair. Never try to rectify the
problem yourself as this could result in serious injury and/or property damage.
18