WayteQ X920BT Bedienungsanleitung Seite 86

English
E. Memory Card Slot
F. Mini USB
G. Stylus Pen Slot
H. Reset
I. MIC
J. Light Sensor
Once the card is installed, it cannot be removed during the operation of the device.
If you need to remove the card, switch the unit off first, push the card in and it will eject from the slot.
1.2 Charging by Car Charger
Caution: To protect your device against suddenness, please connect the car charger only after the car engine has been
started.
1.3 USB Cable
The USB cable is provided for system upgrades and battery charging . This USB cable will work on the PC either with
Microsoft Active Sync® or as a mess storage media. You can select the mode in the "Setting-USB" menu.
1.4 Install the Car Cradle and Bracket
Take off the protection film on the bottom of the suction. Then put the bracket onto a suitable location of your windscreen
or side window and make sure the suction or windscreen is clean without water or any dirty things . Never place the stand
where the driver's field of vision is blocked.
Install the device bracket into the car cradle, after adjust of the angle and direction of the PND, rotate the screw to lock
onto windscreen.
1.5 AC-DC Charger optional
Main Functions Introduction
1. Starting Up and Power Off
Long press the "Power" button to power the equipment on and you can see the main interface as below :
Long press the "Power" button again to enter into the below interface :