Fixing Problems; Warranty - Wolf Garten SDL 2800 EVO Originalbetriebsanleitung

Fixing problems

Problem
Motor does not start.
Motor hums but does not
start
Chopping material is not
pulled in
Chopping material is not
cleanly cut through
When in doubt, always seek out a WOLF Service location.
Attention: Put down the appliance and pull out the power plug before performing any checks or work on the blades.

Warranty

The warranty rules issued by our company or the importer apply to every
country. As part of the warranty, we remedy malfunctions on your appli-
ance free of charge provided that this malfunction is caused by a material
or manufacturing defect. In the event of a warranty claim, please turn to
your dealer or the nearest branch office.
12
Possible cause
z Not connected to voltage supply
z Faulty connection cable
z Appliance overloaded (the motor is equipped with a
circuit breaker and automatically switches off in the
event of overloading).
z Cutting roller blocked
z Faulty capacitor
z Incorrect switch position
z Chopping material trapped in the hopper
z Too soft or wet chopping material
z Wear on the cutting roller
z Profile plate not set sufficiently
Solution
z Check protection
z Check the cable (electrical expert)
z The motor can be switched back on after
a cooling down break (ca. 5 min.).
z Change direction of rotation, proceed to
switch off appliance and clean.
z Give appliance to authorised WOLF-
Garten customer service centre for re-
pair.
z Adjust direction of rotation
z Change direction of rotation, proceed to
switch off appliance and clean.
z Push with a branch and chop through
z Set cutting unit
z Set cutting unit
en