Husqvarna GTH264T Anleitungshandbuch Seite 20

2
K
C
I
C
TO INSTALL MOWER
1. Set parking brake lever (P) and lower attachment
lift lever (N).
• Depress clutch/brake pedal all the way down and hold.
• Pull parking brake lever (P) up and hold, re lease pres sure
from clutch/brake pedal, then release parking brake lever.
Pedal should re main in brake position. Make sure parking
brake will hold tractor secure.
P . Parking Brake Lever
CAUTION: Lift lever (N) is spring loaded. Have a tight
grip on lift lever, lower it slowly and engage in lowest
position. Lift lever is located on left side of fender.
N
N. Lift Lever
2. Assemble front gauge wheel (W) to front of mower.
W
H
X
Y
Z
3. Turn steering wheel left and position mower.
• Turn steering wheel to the left as far as it will go and position
mower on right side of tractor with deflector shield (Q) to the right.
M
B
L
A
S
D
P
H. Front Mower
Bracket
W. Front Gauge
Wheel
X. Shoulder Bolt
Y. 1¼ O.D.
Washer
Z. 3/8-16 Locknut
F
W
E
H
Engine
Transaxle
4. Slide mower under tractor.
• Bring belt forward and check belt for proper routing in all
mower pulley grooves.
NOTE: Be sure mower side suspension arms (A) are pointing
forward before sliding mower under tractor.
• Slide mower under tractor until it is centered under tractor.
5. Install anti-sway bar (S) (If equipped)
Towards Transaxle.
90° End.
• From right side of mower, first insert 90° end of anti-sway bar
(S) into hole in transaxle bracket (T), located near left rear
tire in front of transaxle.
NOTE: Flashlight may be helpful.
20
A. MOWER SIDE SUSPENSION
ARMS
B. RETAINER SPRING
C. REAR LIFT LINK(S)
D. RIGHT SIDE REAR MOWER
BRACKET
E. FRONT LIFT LINK ASSEMBLY
F. FRONT SUSPENSION BRACKET
H. FRONT MOWER BRACKET
I. LEFT SIDE REAR MOWER
BRACKET
K. BELT TENSION ROD
L. LOCKING BRACKET
M. ENGINE CLUTCH PULLEY
Q. DEFLECTOR SHIELD
S. ANTI-SWAY BAR
W. FRONT GAUGE WHEEL
Front
02965
Q. Deflector Shield
Back
A
A. Mower Side
Suspension Arms
Q. Deflector Shield
02965
Anti-Sway Bar (S)
Towards Mower Deck
Integrated Washer End
Q
Q