Filling The Water Compartment; Low Water Level; Using The Steamer With Built-In Automatic Refill System; Draining And Cleaning The Water Tank - Sawotec SAVC-90N Installationsanleitung

3.4.1. Filling the Water Compartment

Fill the Tank by pouring water through the holes designated for the Scent Basins.
•
The amount of water poured can be monitored using the Water Level Indicator.
•
The water should not exceed the 5-liter marking on the Level Indicator; otherwise it might spill on
•
the floor.
If "FILL" is displayed on the external control unit, refill the Water Tank. Be careful in removing the
•
Scent Basins during bathing, as they will be hot to touch. Do not attempt to remove the Steamer
Cover, as it will be extremely hot to touch.
Always make sure that there is a sufficient amount of water in the Water Tank before using the
•
Steamer.

3.4.2. Low Water Level

The Combi Heater is equipped with a Low Water Level Detection System, which prompts the user
•
to refill water before the Water Tank runs dry.
The Low Water Level Detection System will display "FILL" on the external control unit when only
•
about 1-liter water is left in the tank. A warning sound (buzzer-like) will also be emitted to catch
the user's attention. The tank should then be refilled with water.
If, despite the "FILL" message and warning buzzer, water is not refilled, the Steamer will eventually
•
run dry, which negatively affect the life time of the heating plate.

3.5. Using the Steamer with Built-in Automatic Refill System

The Combi Heater is equipped with an automatic water refilling system that makes it possible to
produce the steam without refilling water manually.
The Steamer Tank will automatically be refilled with water upon turning ON the control unit
and will be refilled with water automatically once the water level is already near the low-water
detection mark.
As a security feature, if the Water Tank is not refilled automatically for any possible reason, the Low
Water Detection System will automatically turn off the Steamer. And the word "FILL" will be
displayed on the external Control Unit and a warning sound (buzzer-like) will be emitted. (Refer to
Part5 Troubleshooting)
NOTE: Make sure that there is enough supply of water and the water supply pressure must be in
the range of 1 to 2 bar to have a smooth automatic refill system function and check the water
connection that it is properly connected to the water inlet of the steamer before turning ON the
steamer ( Refer to Figure 1 ).

3.6. Draining and Cleaning the Water Tank

The Water Tank should be emptied and cleaned after every use to ensure that always fresh and
clean steam is produced.
Wait for the unit to cool down before draining the water.
To drain the water, turn the Ball Valve handle at the bottom of the Steamer Tank counterclockwise
until water flows out of the tank. Provide a container to collect the water.
For the Super Savonia Combi, both tanks shall be drained.
Every 500 hours of use or 6 months whichever comes first, disconnect the connection hose of the
two tanks and rinse with water to remove particles inside the hose that will cause water clog up.
Do not forget to connect back the hose of the two tanks after cleaning. See Figure 9.
Once the tank is completely drained, remove the Steamer Cover and clean the tank inside with a
household brush to remove impurities that have accumulated in the tank, and then rinse with
water.
21