ADE BA 831 Britta Bedienungsanleitung Seite 5

Statutory instruc tions on battery disposal
Batteries must not be disposed as household waste. The law requires that you, as
consumer, return the waste batteries either to public collection points in your town or
village or to any outlet selling batteries of the same kind.
Note:
Batteries are marked as follows:
Li = Battery contains Lithium
Al = Battery contains Alkali
Mn = Battery contains Manganese
CR (Li); A (Al, Mn); AA (Al, Mn); AAA (Al, Mn)
Safety instruc tions for lithium batteries (CR2032/CR2430):
1. Lithium batteries are lithium manganese cells. If you do not use the scale over a longer
period, you should take out the batteries of the device.
2. Never open the lithium battery, do not put into fire, or expose to shocks because an
explosion risk lasts or discharge of poisonous exposure to fumes might possible.
3. Never touch leaked cells with bare hands.
4. When eyes or hands are contaminated, it is essential to rinse with lots of water. You
should go to a doctor if skin or eyes are irritated.
5. Dispose cells only completely discharged or protected against polarity reversal
wrapped according to your local disposal regulation.
6. Do not expose the cells to direct solar radiation and store away from heat;
otherwise, there is risk of overheating.
7. Maintain a storage temperature of < 40°C.
Disposal of old electrica l and electronic equipmen t
This symbol on the product or on its packaging indicates that this
product shall not be treated as household waste. Instead, it shall
be handed over to the applicable collection point for the recycling
of electrical and electronic equipment. For more detailed
information about recycling, contact your local city office, your
household waste disposal service or the shop where you
purchased the product.
With kind regards
ADE (GmbH & Co.)
8
Operating Manual_N_BA831_BFS803_EN_091117_REV002
Model Britta / BA 831
Instruction Manual
Directory
1. How does the body analyser work?
2. Conditions to use
...............................................................page 2
3. Commissioning
....................................................................page 3
4. Weighing function
(weight measurement only)
5. Programming
/ enter of personal data
6. Body Analysis
.......................................................................page 5
7. Error Messages
...................................................................page 7
8. Technical Data
.....................................................................page 7
9. Warranty
.................................................................................page 7
1
........................page 2
..
...............page 4
..............................page 4