Installing The Heater; Filling Fuel - Zibro SRE 172 E Gebrauchsanweisung

MANUAL
A

INSTALLING THE HEATER

Carefully remove your Zibro from the box and check the contents.
1
In addition to the heater you also need to have:
a manual fuel pump
a transportation cap
these directions for use
Keep the box and the packaging materials (Fig. A) for storage and/or
transportation.
2 Open the lid of the removable tank
3 Fill the removable tank as indicated in Section B.
The floor should be firm and completely level. Reposition the heater, when it
4
is not level. Do not try to correct the situation by placing books or other
goods under the heater. Please refer to the separate instruction in the carton
box for fixing of the heater.
Insert the plug ¸ into the wall-socket (220/230 Volts - AC / 50 Hz) and set the
5
correct time using the adjustment keys
Your Zibro is now ready for use.
6
B

FILLING FUEL

Do not fill the removable tank in the living room, but in a more suitable place
(there can always be some spillage). Follow the procedure below:
B
Make sure that the heater is switched off.
1
Open the lid
2
Some drops may leak from the tank. Put down the removable tank (cap
pointing upwards) and screw off the fuel cap.
C
Take the manual fuel pump and insert the smooth, most rigid tube into the
3
jerrycan. Make sure that it is in a higher position than the removable tank
(Fig. C). Insert the ribbed hose into the opening of the removable tank.
Lock the switch button on top of the pump (turn clockwise).
4
Squeeze the pump a few times, until fuel starts flowing into the removable
5
tank. As soon as this happens, there is no need to press any longer.
and remove the piece of cardboard.
and lift the removable tank
(refer to Section C).
out of the heater (Fig. B). Note:
4
45