Maintenance - Zibro SRE 168 E Gebrauchsanweisung

K: When the FUEL
indicator light is lit, the
information display will
show the number of
minutes of fuel left in
the tank.
L: A blinking VENT
indicator light is a sign
that you need extra
ventilation.
M
Fuel filter
N
J
THE 'FUEL' INDICATOR LIGHT
When the indicator light FUEL lights up, it means that there is only fuel left for 10
more minutes. The count-down of the remaining heating time can be seen in the
information display ¹ (Fig. K). Now you have two options:
you remove the fuel tank and refill it outside the living room (section B) or
you push the button EXTENSION
heating time will extend to 90 minutes. The heater will automatically switch
back to its lowest position. In the display the number 90 will appear, which
will decline to 10. At the arrival of 10, you will hear an alarmsignal every two
minutes, warning you to refill the removable tank. If you do not react, the
heater will extinguish by itself. The heater will also sound a warning signal,
when it switches off. The fuel indicator light will blink, while four lines (--:--)
are blinking in the information display. You can stop this by pressing the
button once more.
Once the heater has used up all its fuel and extinguished, it will take some time,
after the refill, before the heater is completely ready for use again.
K
THE 'VENT' INDICATOR LIGHT
When there is insufficient ventilation in the room, an intermittent buzzer will be
heard (approximately once each ten minutes) and the VENT indicator will be lit.
When this signal is given, ensure that the ventilation of the room is improved (e.g.
by opening a door or window a little more), to avoid that the heater shuts off.
When the ventilation of the room is improved, the VENT indicator and buzzer will
be deactivated. When there is still insufficient ventilation, the heater shuts off
automatically. When this occurs, e -1 1 is displayed and the VENT indicator is
blinking. After improving the ventilation of the room (e.g. by opening a door or
window a little more), the heater can be ignited by pushing
If the indicator light continues blinking after extra ventilation, please contact your
Zibro dealer.
L
THE IONIZER FUNCTION
The ionizer can be activated by pressing the IONIZER
negative ions are generated, bringing 'air vitamins' to a natural level. This
function can be used when the heater is de-activated also. To switch off the
ionizer function, the IONIZER
M

MAINTENANCE

Switch off the heater and let it cool down, before you start any maintenance
work. Also disconnect the plug from the mains. Your Zibro needs hardly any
maintenance. It is, however, important that you clean the air filter cap
vent filter with a vacuum cleaner and the grid
weekly basis. Remove the air filter cap occasionally (Fig. M) and clean it with soapy
water. Prior to reinstallation, make sure that the air filter cap has fully dried.
Regularly inspect the fuel filter as well:
1 Remove the removable tank
(Fig. N). Some drops may leak from the filter; keep a cloth at hand.
. By pushing this button, the remaining
button should be pressed again.
with a damp cloth, both on a
from the heater and remove the fuel filter
again.
button. In this case
and the
4
49