Operation; Units Of Measurement; Cleaning And Care; Installation - STIEBEL ELTRON MEK Bedienungsanleitung

OPERATION | INSTALLATION

Operation

1.3

Units of measurement

Note
All measurements are given in mm unless stated oth-
erwise.
2. Operation
Note
When the water in the water heater is being heated, ex-
pansion water will drip from the outlet.
With non-pressurised water heaters with anti-drip func-
tion, the expansion water remains inside the water heat-
er.
To draw water, lift the lever.
To achieve the required temperature, mix the cold and hot water
by moving the lever sideways.
MEB: You can switch between spout and hand shower. For this,
pull the diverter upwards while the water is running.
The tap automatically reverts to the original position after draw-
off has ended.
3.

Cleaning and care

f Never use abrasive or corrosive cleaning agents. A damp f
cloth is sufficient for cleaning and caring for the product.
f For descaling, remove the aerator from the fitting. f
www.stiebel-eltron.com

INSTALLATION

4.

Safety

Only qualified contractors should carry out installation, commis-
sioning as well as maintenance and repair of the product.
4.1

General safety instructions

We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the product
are used.
WARNING Burns
During operation, the tap can reach temperatures in ex-
cess of 60 °C.
Material damage
!
Scale build-up can block the outlet and thus subject the
water heater to pressure.
f Never block the spout, and use only aerators for f
non-pressurised taps, otherwise the water heater
could be damaged.
4.2

Instructions, standards and regulations

Note
Observe all applicable national and regional regulations
and instructions.
MEK | MED |MEB| 11