Settings And Adjustments - Life & Mobility Mezzo 4 Gebrauchsanweisung

Product description
Markings on the mobility scooter
There are a number of stickers on the mobility
scooter. Below is an overview of these stickers,
with their location.
CE sticker
The mobility scooter meets the provisions of
the Directive for Medical Devices and has a
CE label.
The CE sticker is located underneath the
electronics cover (J) at the rear of your mobility
scooter. Slide the cover backwards and place this
separately.
Attention:
ƒ Always slide the electronics cover forward
again, as it protects the electronic equipment
underneath.
You will hear a click when the electronics
ƒ
cover is in the correct position.
Freewheel sticker (see also page 29)
The sticker above the freewheel lever indicates
the "push position". In this setting the mobility
scooter can be moved freely.
The sticker below the free­wheel lever indicates
that the mobility scooter is ready to be
electrically driven.
Battery connection diagram
The battery connection diagram is located on
the inside of the battery cover. It also includes
the fuse and the motor controls.
EN20
CE sticker
J
Push position
Electric driving position
P
Change seat height
O
Change back angle

Settings and adjustments

You can set up the mobility scooter to meet
all your requirements. It is advisable to contact
your dealer for the correct settings.
Adjusting the seat
Seat height
1. Move the lever (P) upwards (it is located on
the left­hand or right­hand side of the seat,
depending on the configuration chosen).
The seat will go down if you are sitting in it.
The seat will go up if you are standing next
to the mobility scooter.
2. Release the lever (P).
The seat is now locked in its current position.
Back angle
Attention:
Only adjust the backrest when you are sitting
ƒ
in the seat.
The maximum back angle (180°) is only
ƒ
intended for transporting the seat.
ƒ Watch out for overturning:
­ If you have set up the seat with a large back
angle.
­ When driving up a slope.
­ If the slide system is in the rear­most
position.
1. Sit down on the seat.
2. Lift up the lever (O).
3. Use your upper body to push the backrest
backwards into the right position, or:
4. Bend your upper body forward to allow the
backrest to move forward automatically.
5. Release the lever (O).
The backrest is now locked in its current
position.
EN21