Installing The Batteries To The Remote; Connect Power & Antenna/Cable/Satellite; Switching On/Off; First Time Installation - Schaub Lorenz 40LE-E6800 Bedienungsanleitung

Installing the Batteries to the Remote

1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.
Connect Power & Antenna/Cable/Satellite
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.

Switching On/Off

To Switch the TV On
Connect the power cord to the 220-240V AC, 50 Hz.
Then the standby LED lights up.
To switch on the TV from standby mode either:
Press the " " button, P+ / P- or a numeric button on
the remote control.
Press the control switch located on the left side of the
TV. The TV will then switch on.
To Switch the TV Off
Press the " " button on the remote control or press and
hold the control switch on the TV until the TV shuts
down, so the TV will switch to standby model.
To power down the TV completely, unplug the power
cord from the mains socket.
Note: When the TV is switched to standby mode, standby LED
can blink to indicate that features such as Standby Search,
Over Air Download or Timer is active. The LED can also blink
when you switch on the TV from standby mode.

First Time Installation

When turned on for the first time, the "language
selection" menu appears. The message "Welcome
please select your language!" is displayed in all
language options listed alphabetically.
Press the "
required language, press OK button to select.
"First Time Installation" appears. Use " " or "
" button to set the required country, and press
" " button to select Search Type. Use " " or
" " to set the desired search type. Available
search types are Digital and analog, digital only
and analog only. When set, press "
Teletext Language. Use " " or " " button to set the
"Teletext Language" and select "Scan Encrypted"
using " " or "
Encrypted as Yes if you want to scan coded stations.
Default PIN code can change depending on the
selected country. If you are asked to enter a PIN code
for viewing a menu option, use one of the following
codes: 4725, 0000 or 1234.
Press OK button on the remote control to continue and
the following message will be displayed on the screen.
English - 41 -
" or " " button to highlight the
" button. You can set Scan
" to select