Time Program Function; A Hotplate Should Switch Off Automatically; The Timer; Cleaning Lock Function - Blaupunkt 5II6.3.0 Gebrauchsanleitung

Time program function

This function may be used in two different ways:
to automatically switch off a hotplate
■
as a timer
■

A hotplate should switch off automatically

The hotplate switches off automatically after the time that is set
has elapsed.
Set the cooking time.
The hob must be switched on.
Select the hotplate and the required heat setting.
1.
Touch the symbol.
0 x
2.
hotplate. appears in the timer display.
‹‹
Touch the + or - symbol. The following basic setting appears:
3.
+ symbol: 30 minutes.
- symbol: 10 minutes.
Touch the + or - symbol until the required cooking time
4.
appears.
After a few seconds, the cooking time begins to elapse.
Notes
The same cooking time can be set automatically for all
■
hotplates. The set time for each of the hotplates counts down
independently.
The Basic settings section contains information on
automatically programming the cooking time.
If the combi zone or move function is selected when the
■
hotplates are combined, the set time is the same for both
hotplates.

Cleaning lock function

Cleaning the control panel while the hob is switched on may
change the settings.
In order to avoid this, the hob has a cleaning lock function.
Press the symbol. A signal sounds and the indicator lights
R
up. The control panel is locked for 35 seconds. The control

Automatic time limitation

If the hotplate remains in use for a long time and no changes
are made in the settings, the automatic time limitation function
is triggered.
The hotplate stops heating. The
heat indicator œ / • flash alternately in the display.
lights up in the display for the
" , ‰ symbol and the residual
Changing or cancelling the time
Select the hotplate . Press the
cooking time with the + or - symbols, or set to
Once the time has elapsed
The hotplate switches off. A warning signal sounds and
appears for 10 seconds in the time program function display.
The indicator on the hotplate lights up. Pressing the
x
symbol turns off the indicators and stops the beeping.
Notes
If cooking times have been programmed for various
■
hotplates, the time programming function always displays the
time for the selected hotplate.
Any cooking time can be programmed for up to 99 minutes.
■

The timer

The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
How to program
No hotplate should be selected.
Press the symbol. The time program function display
0
1.
shows and symbol
‹‹ S
Press the + or - symbols. The basic setting appears.
2.
+ symbol: 10 minutes.
- symbol: 5 minutes.
Set the desired time using the + or - symbols.
3.
After a few seconds, the time will start to elapse.
Changing or cancelling the time
Press the symbol several times until the
0
up. Change the time or set it to
Once the time has elapsed
A warning signal sounds.
function display. After 10 seconds the indicators turn off.
When the symbol is pressed, the indicators turn off and the
0
beeping stops.
panel surface can now be cleaned without the risk of changing
the settings.
Note: The lock does not affect the main switch. The hob may
be turned off when desired.
The indicator goes out when any symbol is pressed. The
hotplate can now be reset.
When the automatic time function is used, it is governed by the
selected power level (from 1 to 10 hours).
symbol and change the
0
.
‹‹
indicator lights
S
with the + or - symbols.
‹‹
is displayed on the time program
‹‹
‹‹
0
39