Seliger AQUALIGHT POWER LED Bedienungsanleitung Seite 16

GETTING STARTED
3 Installation of the jet pipe mount
Unscrew both fi xation screws (A) entirely. Now pull off
the mount of the jet downwards. Stick the jet on the jet
pipe mount and screw the fi xation screws tight.
Fit the light on the jet pipe (B) of the pump with the
enclosed rubber fastener.
4 Installation of wall mount
Unscrew both fi xation screws (A) entirely. Again remove the
mount (B) and screw it tight to the desired position on the wall.
Place the light back in the mount and fasten the fi xation screws (A).
Setting the angle of reflected beam
To set the horizontal angle, simply turn the light into the horizontal
position desired. In order to set the vertical alignment, loosen the
fi xation screws and turn the light into the desired position.
Now fasten the fi xation screws again.
NETWORKING
Stick the plug of the connection cable (optionally available) into the intended socket on the light (Fig.1) and on
the transformer (optionally available) (Fig. 2) fasten the relevant nut cap. In order to switch on the light, stick
the mains plug of the mains adapter in the power pin. The light is now on.
CAUTION! We recommend connecting the spotlights only at temperatures
above 0° C. This will ensure that the cable has the necessary degree of elasticity.
Fig. 1
16 ENGLISH
Fig. 2