Power On Sequence; Front Of The 9600 Plus Calibration Tester; Celsius/Fahrenheit Selection Button - WelchAllyn 9600 Plus Gebrauchsanleitung

Directions for Use

Power On Sequence

The 9600 Plus Calibration Tester receives power from a wall-
mount power pack that plugs into the back of the unit. There is
no ON/OFF switch. On power up, the 9600 Plus Calibration
Tester performs internal self-checks, displays an all-segments
test pattern, beeps and displays the device's current
temperature. The 9600 Plus Calibration Tester immediately
applies heat, if needed, to reach the selected Calibration Set
Point Temperature.

Front of the 9600 Plus Calibration Tester

Temperature Selection Button
This button allows the user to select one of three set point
temperatures: 36.0
°
(105.8 F).
To scroll from one set point to the next, press and hold the
Temperature Selection button until a beep is heard. The newly
selected set point appears in the upper left corner of the LCD
display. The device's current temperature is displayed, will start
to flash, and continue flashing until the cavity reaches the
equilibrium at the new set point.

Celsius/Fahrenheit Selection Button

This button allows the user to select degrees Celsius or degrees
Fahrenheit. To change the temperature units, press and hold the
C/F button until a beep is heard. The temperatures will appear in
either "°C" or "°F" , see
Chapter 2 Controls and Indicators
° ° °
C (96.8 F), 38.5 C (101.3
(Figure 1).
7
° °
F), or 41.0 C