Programme Info (Epg - Only For Dvb-T); Pvr Recording And Time Shift Function (Only In Dtv Mode); Pvr Settings - AEG CTV 2204 Bedienungsanleitung

ENGLISH
74
8. Programme Info (EPG – only for DVB-T)
The Electronic Program Guide (EPG) is broadcast by many, but not all, programme providers. The contents can also
greatly vary.
The EPG shows a daily overview of current or upcoming programmes with their respective broadcasting times.
1. Press the EPG button to open the programme info.
2. Use the following buttons for changes:
/ :
Select previous/next programmes on the
current channel.
/ :
Select channel.
ENTER: Access selected channel.
INFO: Display detail information about se-lected
programmes.
Yellow
button: Activate date. The dateline is highlighted. Press
/ to access programme info for other days.
REPEAT /
SUBTITLE: Open recording window ( see "9.4 Pro-
grammed Recording with EPG" on page 76).
Green button: Access schedule list in recording
window.
EXIT:
Exit detail informationen or EPG.
Save Programmes
EPG allows you to save the programme start. The programmes are displayed in the schedule list. In on mode 10 seconds
before programme start a promt is shown asking you to switch channels. If no button is pressed or if you press ENTER to
confirm the channel is switched. To carry on watching the current programme select No and press ENTER to confirm.
1. Press the EPG button to open the EPG window.
2. Press the arrow buttons / / / to select the channel and the desired programme.
3. Press the REPEAT / SUBTITLE button.
4. In the next window confirm the values with ENTER or change the values. The recorder schedule list with all saved
programmes is displayed.
5. Press EXIT to close the window.

9. PVR Recording and Time Shift Function (Only in DTV Mode)

Important! Before recording the media must be formatted. Existing files are deleted. Check to make sure that no impor-
tant information is saved on the media. Format the media according to "9.1 PVR Settings" ( see page 74).

9.1 PVR Settings

1. Press the MENU button to display the OSD main menu.
2. In the main menu select CHANNEL, press
System and press ENTER.
• Select Disk
Select "DISK C:" and "OK" and press ENTER to confirm.
• Check PVR File System
Check the connected USB device. Select OK to check the disk.
• Format
Select OK to format the disk.
overview
to select PVR File