D - Series Specifications - DIGAM Q 3002 Bedienungsanleitung

D - Series specifications

General
Type
Power requirements:
Power factor cos(ϕ)
Operating temperature
Weight
External dimensions
Consumption average
Audio section
Bandwidth (1W, 8Ω)
Damping factor (8Ω)
Slew Rate (8Ω)
S/N ratio
Distortion
Intermodulation SMPTE
Intermodulation DIM 100
Inputs
Impedance
Gain
Outputs
Output specifications
Power RMS x Channel (W)
2 Channels working
(1KHz, 0.5% THD) 2 Ω
* EIAJ Test 4 Ω
8 Ω
2 Channels working
(1KHz, 1% THD) EIAJTest 2 Ω
4 Ω
8 Ω
Functions
Power Factor Correction System (PFC)
Led bar indicator / Over-temperature forecasting / Thermal protection / Gain control / Short-circuit / Over-load output protection / Temperature
controlled air-cooling system / Clip limiter and permanent signal compressor / Gate selection / Selecteable active filter HP, LP, BP 12dB/Oct.
65,100,130 Hz
Options
Remote control interface
POWERSOFT
D 1502 D 2002
Single Bridge Single Bridge Single Bridge Single Bridge Single Bridge Single Bridge
720 NA 950 NA
390 1440 570 1900
250 780 350 1140
750 NA 1000 NA
400 1500 600 2000
250 800 350 1200
ENGLISH - 11
Digital amplifier for professional applications
115-230Vac 50-60Hz +15/-15%
More than 0.95 from 200W to full power
0°C ÷ +45°C
8.5 kg
Standard rack 19" (W), 1 units (H), 455mm (D)
500/900 VA
5 Hz ÷ 30 kHz
100 Hz = 600 10KHz=100
40V/µs (input filter bypassed)
>105 dB/A (20Hz to 20KHz)
THD: Max < 0.5% from 0.1W at full power (typically < 0.1%)
Max < 0.5% from 0.1W at full power (typically < 0.1%)
Max < 0.02% from 0.1W at full power (typically < 0.01%)
Balanced to ground, XLR female combo jack 6.3mm
10 KΩ each leg, balanced to ground
32 dB (32, 30, 28, 26, 24, 22, 20, 18, 14, 4, -∞, control knob
detent selection)
Neutrik 4-pole speakon connectors [pins 1+ 1 – (2+/2-
bridge)]
D 1604 D 3002
NA NA 1440 NA
780 NA 800 2880
500 1560 500 1600
NA NA 1500 NA
800 NA 830 3000
500 1600 500 1660
D 2004 D 4002
NA NA 2000* NA
950 NA 1040 4000*
600 1900 650 2080
NA NA 2000 NA
1000 NA 1100 4000
600 2000 650 2200
E