Technical Information - AEG FAVORIT 65020 VI Benutzerinformation

Problem
Dry water drop
stains on glasses
and dishes.
The dishes are wet.
The dishes are wet
and matt.
Activating the rinse aid
dispenser with the multitab
function activated
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to 'SET-
TING AND STARTING A PRO-
GRAMME'.
2. Press and hold buttons (4) and (5) at
the same time until the indicators of
buttons (3), (4) and (5) flash.
3. Press button (4).
• The indicators of buttons (3) and (5)
go off.

TECHNICAL INFORMATION

Dimensions
Electrical connection
Water supply pressure
Water supply
Possible cause
The quantity of detergent
was too much.
The released quantity of
rinse aid was not sufficient .
The quality of the detergent
can be the cause.
The programme had no
drying phase.
The rinse aid dispenser is
empty.
The quality of the rinse aid
can be the cause.
The quality of the combi
detergent tablets can be
the cause.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
1)
Cold water or hot water
Possible solution
Make sure that you add the
correct quantity of detergent
in the dispenser before you
start a programme.
Increase the released quanti-
ty of rinse aid.
Try a different brand of de-
tergent.
Set a programme with the
drying phase.
Make sure that there is rinse
aid in the rinse aid dispenser.
Try a different brand of rinse
aid.
• Try a different brand of
combi detergent tablets.
• Activate the rinse aid dis-
penser and use the rinse
aid together with the com-
bi detergent tablets.
• The indicator of button (4) contin-
ues to flash.
• The display shows the setting of the
rinse aid dispenser.
4. Press button (4) to change the setting.
5. Deactivate the appliance to confirm
the setting.
6. Adjust the released quantity of rinse
aid.
7. Fill the rinse aid dispenser.
596 / 818 - 898 / 550
(0.5 / 0.05 ) / (8 / 0.8 )
2)
ENGLISH
39
Off
On
220-240 V
50 Hz
max. 60 °C