Activating And Deactivating; Automatic Switch-Off; Automatic Heat Up; Power Function - Leonard LAI8000F Benutzerinformation

Activating and deactivating

Touch for 1 second to activate or
deactivate the hob.
Automatic Switch Off
The function deactivates the hob
automatically if:
• all cooking zones are deactivated,
• you do not set the heat setting after you
activate the hob,
• you spill something or put something on
the control panel for more than 10
seconds (a pan, a cloth, etc.). An
acoustic signal sounds and the hob
deactivates. Remove the object or clean
the control panel.
• the hob gets too hot (e.g. when a
saucepan boils dry). Let the cooking
zone cool down before you use the hob
again.
• you use incorrect cookware. The symbol
comes on and the cooking zone
deactivates automatically after 2
minutes.
• you do not deactivate a cooking zone or
change the heat setting. After some time
comes on and the hob deactivates.
The relation between the heat setting
and the time after which the hob
deactivates:
Heat setting
, 1 - 2
3 - 4
5
6 - 9
The heat setting
Touch to increase the heat setting.
Touch to decrease the heat setting.
Touch and at the same time to
deactivate the cooking zone.
The hob deacti-
vates after
6 hours
5 hours
4 hours
1.5 hour

Automatic Heat Up

If you activate this function you can get a
necessary heat setting in a shorter time.
The function sets the highest heat setting
for some time and then decreases to the
correct heat setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch (
touch ( comes on). Immediately touch
until the correct heat setting comes on.
After 3 seconds
To deactivate the function: touch

Power function

This function makes more power available
to the induction cooking zones. The
function can be activated for the induction
cooking zone only for a limited period of
time. After this time the induction cooking
zone automatically sets back to the highest
heat setting.
Refer to "Technical information"
chapter.
To activate the function for a cooking
zone: touch .
To deactivate the function: touch
.
Timer
Count Down Timer
You can use this function to set how long
the cooking zone should operate for a
single cooking session.
First set the heat setting for the cooking
zone then set the function.
To set the cooking zone: touch
and again until the indicator of a necessary
cooking zone comes on.
To activate the function or change the
time: touch or
Leonard 25
comes on). Immediately
comes on.
comes on.
again
of the timer to set the
.
or