Hints And Tips - AEG HKP67420FB Benutzerinformation

General information:
• 160 mm is the minimum bottom
diameter of the cookware for this
function.
• Heat setting display for the left rear
control bar shows the position of the
cookware on the induction cooking
area. Front
.
• Heat setting display for the left front
control bar shows the heat setting. To
change the heat setting use left
front control bar.
• When you activate the function for the
first time you will get heat setting

6. HINTS AND TIPS

WARNING!
Refer to Safety chapters.
6.1 Cookware
For induction cooking zones
a strong electro-magnetic
field creates the heat in the
cookware very quickly.
Use the induction cooking
zones with correct cookware.
, middle , rear
for the front position,
middle position and
position.
You can change the heat settings for
each position separately. The hob will
remember your heat settings next
time you activate the function.
Activating the function
To activate the function place the
cookware in the correct position on the
cooking area. Touch
above the symbol comes on. If you do
not place the cookware on the cooking
area comes on and after 2 minutes
the flexible induction cooking area is set
to .
Deactivating the function
To deactivate the function touch
set the heat setting to
above the symbol
Cookware material
• correct: cast iron, steel, enamelled
steel, stainless steel, the bottom
made of multi-layer (with correct mark
from a manufacturer).
• not correct: aluminium, copper,
brass, glass, ceramic, porcelain.
Cookware is correct for an induction
hob if:
• some water boils very quickly on a
zone set to the highest heat setting.
• a magnet pulls on to the bottom of
the cookware.
ENGLISH 15
for the
for the rear
. The indicator
or
. The indicator
goes off.