Remote Control - Changing The Batteries; Connections; Basic Handling Of The Tv Set; Power On/Off - TechniSat Tareo 26 Bedienungsanleitung

Remote control - Changing the batteries

1. Open the cover on the battery compartment at
the rear of the remote control by pushing it in the
direction of the arrow and then lifting it.
2. Insert the supplied AAA batteries, ensuring that the
poles are in the right direction (indicator visible in
battery compartment).
3. Close the battery compartment again.
Connection
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
VGA
13V dc /18V dc
SPDIF

Basic handling of the TV set

Power On/Off

To Switch the TV On
• Switch the " " button on the rear left hand side
to position "|" so the TV will switch to standby mode.
Then the standby LED lights up.
To switch on the TV from standby mode either:
a. Press the On/Standby button, program +/- or a
numeric button on the remote control.
b. Press the middle of the "
By either method the TV will switch on.
Switching the TV Off into Standby mode
• Press the On/Standby button on the remote control
Switching the TV Off using the power switch
• Switch the "
To turn off the TV completely, remove the power
cord plug from the mains power socket.
the TV is switched to standby mode, standby LED can
blink to indicate that features such as Standby Search,
Over Air Download or Timer is active. The LED can also
blink when you switch on the TV from standby mode.
When turned on for the first time, the "language
selection" menu appears. The message "Welcome
please select your language!" is displayed in all
language options listed alphabetically.
Satellite
Press the up/down arrow keys to highlight the
required language, press OK button to select. "First
Aerial or Cable
Time Installation" appears. Use the right or left arrow
DiSEqC
Switch
keys to set the required country, and press the down
arrow key to select Search Type (optional).
Use the right or left arrow keys to set the desired
search type. Available search types are Digital and
analog, digital only and analog only.
Next, select Scan Encrypted and set as Yes if you
want to scan coded stations.
" button on the TV.
- 33 -
or press the " " button, so the TV will switch to
standby mode.
" button to position 2 as illustrated,
so the TV will switch OFF.
NOTE: The mode is shown thanks to an LED. When

Initial Installation