AEG SKS91240F0 Benutzerinformation Seite 28

28 www.aeg.com
Problem
The lamp does not
work.
The compressor op-
erates continually.
The compressor
does not start imme-
diately after press-
ing the COOLMATIC
or FROSTMATIC
switch, or after
changing the tem-
perature.
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
The temperature in
the appliance is too
low/high.
The temperature in
the refrigerator is
too high.
Possible cause
The appliance has no
power. There is no volt-
age in the mains socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not
set correctly.
The door is not closed
correctly.
The door has been
opened too frequently.
The product temperature
is too high.
The room temperature is
too high.
This is normal, no error
has occurred.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
The temperature regula-
tor is not set correctly.
There is no cold air circu-
lation in the appliance.
Solution
Connect a different electri-
cal appliance to the mains
socket.
Contact a qualified electri-
cian.
Close and open the door.
Refer to "Replacing the
lamp".
Set a higher temperature.
Refer to "Closing the
door".
Do not keep the door
open longer than necessa-
ry.
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Decrease the room tem-
perature.
The compressor starts af-
ter a period of time.
This is correct.
Clean the water outlet.
Make sure that products
do not touch the rear
plate.
Set a higher/lower temper-
ature.
Make sure that there is
cold air circulation in the
appliance.