What To Do If - AEG SKS68800F0 Benutzerinformation

WHAT TO DO IF...

During operation of the appliance some smaller but annoying trouble can often occur,
which does not require calling a technician out. In the following chart information is given
about them to avoid unnecessary charges on service.
The operation of the appliance goes with certain sounds (compressor and circulating
sound). This not means a trouble, but a normal operation.
The appliance operates discontinuously, so the stopping of compressor does not mean be-
ing no current. That is why you must not touch the electrical parts of the appliance before
breaking the circuit.
Problem
The compressor operates
continually
The sound level in the
cabinet is too high
Water flows at the back
plate of the refrigerator
Water flows into the re-
frigerator compartment
Water flows onto the
floor
The lamp does not work.
It is too warm in the re-
frigerator
Possible cause
The Temperature regulator may
be set incorrectly
The door does not close tightly
or it is not shut properly
The door has been opened too
frequently
Food placed in the appliance was
too warm
The temperature of the room
that contains the appliance is
too high for efficient operation
The pipes, at the back of the
cabinet, touch each other
During automatic defrosting,
frost melts on the back plate
The outlet can be clogged up
Products placed in can prevent
water from flowing into the col-
lector
The melting water outlet flows
not into the evaporative tray
above the compressor
The lamp is in stand-by.
The lamp is defective.
The Temperature regulator may
be set incorrectly
What to do if...
Solution
Set a warmer temperature
Check if the doors close well and
the gaskets are undamaged and
clean
Do not leave the door open longer
than necessary
Allow food to cool to room tem-
perature before storing
Try to reduce the temperature in
the room where the appliance
stands
Carefully bend them
It is normal
Clean the outlet
Replace the products so that they
can not touch the back plate di-
rectly
Put the melting water outlet to
the evaporative tray
Close and open the door.
Refer to "Replacing the lamp".
Set a lower temperature
31