Technical Specification - Arcam Neo Handbuch

technical
specification
Pre-amplifier
Inputs
Maximum input level
Input impedance
Signal/noise ratio
Co-axial outputs
Maximum output level
Output impedance
Optical output (TOSLINK)
Sample rate
Amplifier
Continuous power output, per channel, 80khz measurement bandwidth
Both channels, 4Ω, 1kHz
Distortion, both channels 4Ω, 80% power, 1kHz
CD playback
DAC
Frequency response (±0.5dB)
DAB receiver
RF tuning range
Sensitivity (typical)
Input impedance
FM receiver
RF tuning range
Sensitivity (typical)
Signal/noise ratio (at 200mV)
Distortion (THD at 200mV)
2.5Vrms
47kΩ
105dB
2.5Vrms
500Ω
44.1kHz (with CD playback),
48kHz (with DAB, FM, NET & USB receiver),
otherwise muted.
75Wrms, 0.013% THD+n
0.011% THD+n
Wolfson 24-bit multilevel Delta-Sigma DAC
20Hz–20kHz
174.928—239.200MHz (Band III)
1452.960—1490.624MHz (L-band)
–97dBm
75Ω
89.5–108MHz
-108dBm
50dB
0.3%
General
Supply voltage*
Power consumption
Size (W x D x H)
Weight (net)
Weight (packed)
Supplied accessories
* This is a Class 1 device and must be earthed.
Radio interference
Solo Neo is an audio device containing microprocessors and other digital electronics. It has been designed to
very high standards of electromagnetic compatibility.
If Solo Neo causes interference to radio or television reception (which can be determined by switching Solo Neo
off and on), the following measures should be taken:
Re-orient the receiving antenna or route the antenna cable of the effected receiver as far as possible from
<
Solo Neo and its cabling.
Relocate the receiver with respect to Solo Neo.
<
Connect the receiver and Solo Neo to different mains outlets.
<
If the problem persists, please contact your Arcam dealer.
E20
100V, 115V or 230V AC,
depending on shipping region
Standby 1W;
Operational 25W (typical), 400W (maximum)
W430mm x D350mm x H79mm
7.75kg
10.5kg
Mains lead
Wire dipole aerial (Band III)
Wi-Fi antenna
Remote control handset and two AAA batteries
Instruction manual and registration card