Electronic Programmer - EHC 2013CC Serie Bedienungsanleitung

OPERATION

Electronic programmer*

work time
-
A
turn-off time
-
timer
-
current time
-
1 - programmer work function selection
button
2 - button „-"
3 - button „+"
Current time set-up
After plugging in or reconnecting to a power
source after current decay, the dis play shows
12.00, and the lamp at
• set up the current time using buttons 2
and 3.
1200
About 5 sec. after the time set-up has been
finished, new data will be memo rized and the
lamp at will go out.
The time correction can be done later, press-
ing button 1 until the lamp at
Then you can correct the current time.
Notice!
If the current time is not set up, it is im possible
for the oven to work.
*optional
flashes,
starts to flash.
23
8888
A
2
Timer
You can activate the timer at any time, regard-
less the activity state of other pro grammer
functions. The measured time ranges from 1
minute to 23 hours 59 minutes. With the aim
of setting up the timer:
• press button 1 until the lamp at
flash, and the dis play shows "0.00",
•set up the timer using buttons 3 and 2,
The set-up time is pre sented on the display,
and the lamp at
005
After the set-up time has elapsed, a sound
signal turns on and the lamp at
flash again,
• press buttons 1, 2 or 3 to turn the signal
off; the lamp will go out, and the display will
in di cate the current time.
Notice!
If the sound signal is not turned off manu-
ally, it will turn off au to matically after about
2 minutes.
1 3
starts to
is turned on.
starts to