Product Description; Intended Use - Mali Racing 3002 Anleitung

Check the temperature of the battery occasionally during charging. NiMH and NiCd batteries can heat up con-
siderably especially at high charge currents (> 1C). The battery may be damaged on excessive heating (>50°C).
In such a case, reduce the charge current.
Already charged or fully discharged batteries should not be connected and charged.
Never charge/discharge damaged, expired or deformed rechargeable batteries. There is a danger of fire and
explosion!

3. Product description

The model is an all-wheel drive RC car chassis with a pre-installed brushless electric motor and a 2.4 GHz receiver
station, a programmed, electronic speed controller and steering servo with metal transmission.
The RC Buggy is pre-assembled in drivable condition and is delivered with a 2-channel remote control transmitter
and a 3500 mAh LiPo battery as well as a balance-charger for the battery.
This model is intended both for operation on indoor tracks as well as operation outdoors.
The bodywork, which is ready-printed and cut out as well as the rear spoiler with a carbon look makes for a classy
visual impression, and the decals included can be used to customise your model.
The twin-deck chassis made of anodised aluminium is light-weight and torsion-resistant. The chassis obtains
additional sturdiness from a top deck made of anodised aluminium. Plastic shells bolted to the side of the chassis
protect the installations against spray water and flying rocks.
A low-maintenance brushless motor provides satisfaction with higher power, greater torque and a higher efficien-
cy factor than conventional brushed motors. A heat sink ensures heat dissipation even under the most severe con-
ditions. The unit is powered by the motor pinion on the centre differential. From there one drive shaft each made
of metal meshes in the encapsulated differentials of the front and rear axles, thus bringing about four-wheel drive.
The differentials in the front and rear axles provide for speed compensation between the wheel on the inside and
the wheel on the outside of curves and has metal gears. The model is entyrely ball-bearing-mounted.
A programmable electronic speed controller KL-60 with a fan attached is geared in optimum fashion to the brush-
less motor and provides satisfaction through excellent starting behaviour, acceleration and excellent synchronisati-
on.
The high-performance RS 90MGBB steering servo with metal gearbox and two ball bearings has high controlling
torque amounting to 88.3 Ncm and high control speed with maximum stability. A servo saver also provides pro-
tection for the servo against sharp impacts against the wheels.
In this 2.4 GHz remote control set with 2 channels, you have a radio control system that is ideally suited for prima-
rily model cars and model ships. Its proportional control channels allow 2 control functions to be remotely cont-
rolled independent of one another.
The 2.4 GHz transmitter and the receiver tuned to it do not work on a frequency predetermined by the sender
and receiver crystal. Each time they are switched on, the transmitter and receiver scan the frequency band for an
available, open frequency on which the radio link is then established.

Intended use

This product has been designed solely for private use in the field of modelling and has operating times appropria-
te to this use.
This product is not approved either for commercial or industrial nor for continuous operation.
Any improper use can result in endangerment to people as well as damage to the product and dangers involved
in such, like the loss of control over the model, short-circuits, fires, electric shock, etc.
Comply with the safety instructions in these Operating Instructions. They contain important information on how to
handle
this product.
The product is suitable for children under 14 years only under adult supervision.
24