Editing Text - LG LN54 Series Benutzerhandbuch

12
UsInG LG ezsIGn 3.0 eDItoR

Editing Text

Click a text area to edit the text inside the area. You
can also use the text properties edit pop-up win-
dow, which appears when you click a text area, to
change the properties of the selected text area.
When a text area is selected, the properties editing
pop-up window illustrated below appears. the
following properties can be changed.
ꔈ Bold
ꔈ Underline
ꔈ Italic
ꔈ Color
ꔈ font size
ꔈ font
ꔈ text direction
(left to right/right to left)
ꔈ Alignment
(left/center/right)
ꔈ text flow
(none/slow/normal/fast)
Note
ꔈ for the font area, the input length may vary
depending on the font size.
ꔈ If the text entered exceeds the maximum num-
ber of characters available for the input box and
the flow speed function is not enabled, the text
will be cut off when the content is displayed on
tV.
ꔈ You can type only a limited amount of text. (Up
to 2700 pixels). If the text you enter exceeds
the maximum length, the input of text will be
limited.
ꔈ the following elements affect the text length.
Number of characters, font size, font type,
and bold/italic properties
ꔈ When a font is installed on the system, it is also
added to the editor and displayed in the font
list. We recommend installing general ttf
(true type font). the fonts must be installed
on the PC where the ezsign editor has been
installed.
ꔈ some characters may not be entered, or may
be entered but not displayed as normal on the
screen depending on the font type or system
installation environment.
Please use the Preview function to see how the
characters will appear on the tV screen.
ꔈ once the text direction is set, the text flow
direction is determined accordingly. When the
direction is set from left to right, the text flows to
the right, whereas the text flows to the left when
the opposite direction is selected.
ꔈ If you use the same color as the panel saver
content text font, image-sticking may occur on
the panel. therefore, we recommend using a
different color.
ꔈ When text flow property is applied to a text, its
content is applied uniformly to all slides.
ꔈ editing for the selected text area is applied to
the slide below when:
exiting the text edit mode, manually entering
the font size, changing the font type, and
setting the flow property.
ꔈ After editing the text, you can use Preview to
check how the content is displayed on the tV.