Adjusting The Wattage In Tc/Tcr Mode; Locking And Unlocking The Vaporizer Resistance In Tc/Tcr Mode - INNOCIGS iStick Pico Bedienungsanleitung

76

Adjusting the wattage in TC/TCR mode

The output power is between 1 and 75 W in TC and TCR modes� Press the Fire button 4x in quick
succession to adjust the wattage� You can set the wattage by pressing the "Up" or "Down" buttons�

Locking and unlocking the vaporizer resistance in TC/TCR mode

Simply hold down the Fire and "Up" buttons for two seconds in either TC or TCR mode to lock or
unlock the base resistance of the vaporizer� The "Lock" symbol will appear on the display� The "Ω"
symbol will only appear again when the vaporizer is unlocked�
Note
1� Please only use this function at room temperature so that the correct base resistance can be displayed in Lock mode�
2� When you exchange the coil, the battery "saves" the set resistance� This can increase if the temperature increases� If you change
the coil in Unlock mode, the display will show "New coil up same down" and the coil resistance can be reset� If you are continu-
ing to use the same coil, press the "Down" button� If you are using a new coil, press the "Up" button� Please unlock the resistance
if you would like to use an atomizer head with a different resistance�
3� If you accidentally use conventional coils in TC or TCR mode that are not suitable for temperature controlled vaping, or coils
with a resistance greater than 1�5 ohms, the device will automatically switch to VW mode�
SC iStick Pico Box Mod – Selection & Operating of the Modes