Information - SUPERNOVA E3 PRO Anleitung

INFORMATION E3 PRO / E3 PURE / E3 TRIPLE
FOR ALL FRONT LIGHTS
> Never use a high-pressure hose to clean the light. The lens is held in place with a
spring. The pressure of a water jet would push it back and push it back - water
will get into the sealed housing and cannot get out again.
> To ensure the correct function and preserve the longevity of the front light only
Supernova rear lights should be used.
> Always connect the front and rear light with the 2-core wire (no mass connection
to the frame!)
> Please note: Any kind of short circuit will severely impair the function of the light.
Please always insulate unused cable ends of the front light if the rear light is not
installed.
> The fully automated front and tail stand light shines for 4 minutes.
> The cable exits have to point downwards to keep the housings waterproof.
E3 PRO
> With its special beam shape, the Terraflux 2 hybrid lens offers both, an execllent
illumination at night as well as a great daytime running light for your permanent
safety.
E3 PURE 3
> With its special beam shape, the Terraflux 2 hybrid lens offers both, an execllent
illumination at night as well as a great daytime running light for your permanent
safety.
> Additional USB chargers cannot be connected with with the dynamo because
there is not enough energy left for both - the E3 PURE 3 and USB power.
E3 TRIPLE
> Please note! Not road legal; will blind oncoming traffic!
> Automatic activation of the two additional LEDs from 10-15 km/h (6.5- 9 mph)
> No activation of the two additional LEDs if an overvoltage protection or a power
hungry rear light of another brand is used.
DE | EN
6
EN