Shut Down; Troubleshooting - Carson FD Destroyer Buggy Betriebsanleitung

SHut Down

Follow reverse procedure to shut down.
1. Turn off the model.
2. Turn off the transmitter.
• Never touch or hinder rotating tire.
• Never run RC model in the rain or let run over puddles, as water
may cause trouble with RC model.
• The motor and battery may become hot during operation. Take
care when you handle them.
• Remove the batteries from the model and the transmitter when
they are not in use.

troubLeSHootIng

Problem
Model doesn´t move
Loss of control
Doesn´t run straight
Doesn´t stop
Doesn´t reverse
Running too slowly
GB // 22
cautions when handling batteries/
rechargeable batteries
Use AA rechargeable/non-rechargeable batteries for the RC
model and AA rechargeable/non-rechargeable batteries for the
transmitter.
• Do not recharge battery that is still warm from use as it may
damage the battery. Allow the battery to cool off prior to
recharging.
• Remove transmitter battery when not using it for a long term as
it may leak and damage transmitter when left for a long period.
• Never incinerate used batteries, as they can explode causing
serious accidents.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the model
before being charged.
• Rechargeable batteries are only to be charged under adult
supervision.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the model.
• Please check the electronics, cable, body and other parts
regularly for damage.
Cause
Transmitter or chassis power switch is not
"ON"
Polarity or battery type is wrong
Batteries have run down
Batteries have run down
Antenna is missing or not attached properly
Steering trim is not adjusted correctly
Front and rear wheel nuts are too lose
Throttle trim is not adjusted correctly
Throttle trim is not adjusted correctly
Wrong action
Batteries have run down
Motor has lost power
Rear wheel nuts are too lose
Dust or foreign objects are inside gears
Correction
Switch power on receiver or transmitter
Check polarity and type of battery
Change batteries or charge them
Change batteries or charge them
Attach receiver antenna
Make adjustment
Tighten wheel nuts
Make adjustment
Make adjustment
Control properly
Change batteries or charge them
Change to spare motor
Tighten wheel nuts
Turn the power switch "OFF" and clean out
gears