Programming
Delay function
Only when the clock has been set, the delay function can
be used. In stand-by mode:
• Press
2 times, the display shows
• Press
and
to set the end hour time of delay.
• Press
button again.
• Press
and
to set the end minute time of delay.
• Press
to choose the cooking function you require.
• After set the cooking time and temperature, press
start.
Note:
After setting delay function
the clock,
and „End". Press
end time, after 3 seconds it returns to the current
working state.
Start / Pause / Cancel-Standby
• You can start working mode by pressing
• Pausing is possible by pressing the
• By pressing the
-key two times, you can cancel the wor-
king mode and turn the oven to stand-by-mode.
Energy saving function
• During in waiting state and reminding state , press
three seconds, the display will turn itself off and set to
energy-saving mode.
• If there's no operation in 10 minutes in waiting state, the
display will shut down and go into energy-saving mode.
• In energy-saving mode, press any key or rotate any enco-
der can quit the energy-saving mode.
General operating notes
• The oven light is turned on in all heating modes.
• When you have selected a heating function, but the button
and "End".
be displayed or turn back to waiting state. The selected
function will be recognized as invalid.
• To make sure that your input was detected right from the
SensorTouch-Control panel, a buzzer will sound.
• When a program has finished, a buzzer will sound five
times to remind you when cooking has finished.
to
the screen shows
to inquire the
.
button.
for
is not pressed within 5 minutes, the current time will
33