Power Dynamics PDX115 Dual Gebrauchsanleitung Seite 4

IMPORTANT
Use of controls or adjustments or performance of procedures other than those specified herein may result in
hazardous radiation exposure.
Cd Player Function
1. Power switch-Turn the machine on and off. (Turn it on before amplifier)
2. USB PORT
Support USB playing
3. SD CARD SLOT
4. CD Drawer- Place your CD in here. Use commercially CDs or burning CDs at the minimum speed
possible
5. EJECT BUTTON
Press to load or eject disk. Each press will open or close the disk tray.
NOTE: Disc holder will not open unless stop or pause button has been pushed first.
6. JOG WHEELS
The jog wheels allow you to fast-forward or rewind within a track and to change the playback speed.
Turn the jog wheel clockwise to fast-forward within the track. Turn the jog wheel anti-clockwise to rewind
within the track. The faster you turn the jog wheel, the faster the track will skip forwards/backwards. In
Playback mode rotate the jog wheel clockwise to increase the speed. Rotate the jog wheel anti-
clockwise to decrease the speed.
7. MP3/SD BUTTON
By pressing this button repeatedly, you can select the playback sourceCDdrive/USB interface/SD card
reader.
8. DISPLAY LCD Display indicate the the most important settings and data.
9. CUE BUTTON
Pressing the CUE button during play provides a return to the position at which play was started and will
pause the track. Holding down CUE will start playback from this point and releasing CUE will cause it to
return to that point. So if the track is paused you can use the JOGWHEEL to locate a new cue point.
10. PLAY/PAUSE BUTTON
Each time you press the PLAY/PAUSE button, the operation changes from play to pause or from pause
to play.
11. LOOP IN BUTTON
This button stets the beginning of the loop, the loop indicator flashes.
12. LOOP OUT BUTTON
When you press this button, you set the end point of the seamless loop and you start the loop. To finish
the loop, press again this button
13. RELOOP BUTTON
This button is used to start the last saved loop. To finish the loop, press the re-loop button again.
14. PITCH CONTROL
Use this fader to increase/decrease the speed of the track.
15. VINYL BUTTON
When the LED indicator LED lights, dial the jog wheel for SCRATCH function.
16. SINGLE / CONT BUTTON
Press this button to switch between the SINGLE and CONTINUOUS play mode. The selected mode is
indicated on the LCD. In SINGLE mode, after each track, the unit stops the reading. In CONTINUOUS
mode, the unit reads all tracks and stops.
17. TIME BUTTON
Use this knob to choose the time mode: elapsed time, remaining time or total remaining time. With MP3
files the total remaining time of the CD is not displayed.
18. FOLDER BUTTON
Allows you to navigate through folders similarly in either USB or CD mode. The LED lights will be on.
Press this button, rotary dial will be the folder selection function. Turning clockwise will be the next
folder and counterclockwise is the last folder.