Assigning Target Device Names; Accessing The Names Window; Assigning Names To Target Devices; Assigning Device Types - Fujitsu Siemens Computers KVM s2-0411 Bedienungsanleitung

Assigning target device names

Option Purpose
Devices Specify the number of ports that are on the attached tiered appliance.
Names Assign a unique name to each target device.
Keyboard Specify the keyboard country code.
Scan Set up a custom scan pattern for up to 100 target devices.
Switch Specify the appliance mode.
Network Specify the network speed and configuration, IP address, netmask, and
gateway for the switching system.
Table 3: Setup features to manage routine tasks for the target devices (Continued)
3.5.1 Assigning target device names
Use the Names window to identify individual target devices by name rather than by port
number. The Names list is always sorted by port order. Names are stored in the KVM-
IA, so even if you move the cable or target device to another ARI port, the name and
configuration are recognized by the appliance. If a target device is turned off, you will
not be able to modify the name of the applicable KVM-IA.
3.5.1.1

Accessing the Names window

Press Print Screen to start the OSCAR interface. The Main window opens.
Click Setup - Names. The Names window opens.
If the target device list changes, the mouse cursor will turn into an hourglass as the list is
automatically updated. No mouse or keyboard input is accepted until the list update is
complete.
3.5.1.2

Assigning names to target devices

In the Names window, select a target device name or port number and click Modify.
The Name Modify window opens.
Type a name in the New Name field. Names of target devices can be up to 15
characters long. Valid characters are A through Z, a through z, 0 through 9, space,
and hyphen.
Click OK to transfer the new name to the Names window. The selection is not
saved until you click OK in the Names window.
Repeat steps 1 to 3 for each target device in the switching system.
Click OK in the Names window to save the changes, or click X or press Escape to
exit without saving changes.
3.5.2

Assigning device types

The KVM s2-0411 appliance automatically discovers tiered remote console switchs, but
you must specify the number of ports on the tiered appliance through the Devices
window.Fujitsu Siemens AutoView Console Switches and other earlier-model remote
console switchs are listed in the Type category for the tiered appliance. When you select
18
Basic operations
590-595-609A