Maintenance - Beamz 152.927 Methone 3D Laser Red & Green Gebrauchsanleitung

Attention

MAINTENANCE

Make sure the area below the installation place is free from unwanted persons

during servicing
Switch off the fixture, unplug the mains cable and wait until the unit has been

cooled down.
Housings, fixations and installations spots( ceiling, truss, suspensions) should be

totally free from any deformation
The mains cables must be in impeccable condition and should be replaced

immediately when even a small problem is detected
In order to protect the fixture from overheat the cooling fans (if any) and ventilation

openings should be cleaned monthly.
The cleaning of aperture glass and scanner mirrors must be carried out periodically

to optimize light output. Cleaning frequency depends on the environment in which
the fixture operates: damp. smoky or particularly dirty surroundings can cause
greater accumulation of dirt on the unit's optics
1) Clean with a soft cloth using normal glass cleaning products.
2) Always dry the parts carefully.
3) Clean the Aperture glass at least once every 30 days
The interior of the fixture should be cleaned annually using a vacuum cleaner or

air-jet.
ATTENTION:
Specifications subject to change without prior notice.
The availability of particular products may vary by region. Please check with the dealer.
Attention! L'utilisation en France est autorisée à l'utilisateur professionnel et
non le consommateur. Consultez decret:
Laser will be output from laser aperture in 5 seconds after
the unit is powered on.
We strongly recommend internal cleaning to be carried
out by qualified worker!
www.legifrance.gouv.fr