Bestimmungsgemäße Verwendung
Mit dem HDMI-HDBaseT Receiver Plus PoC werden HDMI-, Ethernet- und Kontroll-Signale (IR & RS232)
bis 1080p und 100 MBit mittels Twisted Pair Kabel bis zu einer Entfernung von 90 m übertragen.
Benötigt werden Transmitter und Receiver.
HDMI-HDBaseT Receiver Plus PoC for the transmission of HDMI, Ethernet and control signals (IR & RS232)
via twisted pair cable over a distance of up to 90 m at 1080p and 100 MBit. Requires transmitter and
receiver.
Lieferumfang
- Contents
•
1 x Receiver Plus
•
1 x Steckernetzteil (24V, 1,25A)
•
1 x Bedienungsanleitung
•
1 x Receiver Plus
•
1 x External power supply (24V, 1,25A)
•
1 x Operating instructions
Sicherheitshinweise
•
Bitte die Anleitung sorgfältig durchlesen und aufbewahren
•
Umsetzer dürfen nur mit Sicherheitskleinspannung betrieben werden
•
Das System darf nur in trockener Umgebung bei Raumtemperatur gelagert und eingesetzt werden
•
Bitte beachten Sie die Sicherheitshinweise der anzuschließenden Geräte
•
Das System muss ordnungsgemäß geerdet sein
•
Da sich das Gerät während des Betriebs erhitzt, ist für ausreichend Belüftung zu sorgen um Schäden
durch Überhitzung zu vermeiden
•
Bei Nichtgebrauch und feuchter Umgebung ist die Stromversorgung zu unterbrechen
•
Bei sämtlichen Arbeiten am Gerät ist grundsätzlich die Stromversorgung zu unterbrechen
•
Das Gerät darf nicht geöffnet werden
•
Vermeiden Sie den Kontakt mit Flüssigkeiten und Chemikalien
•
Please read the instructions carefully and store them
•
The switch must be operated at safety low voltage
•
The unit may only be stored and used in a dry place at room temperature
•
Please note the safety instructions of the connected equipment
•
The system must be earthed properly
•
As the power generating heat when running, the working environment should be maintained fine
ventilation, in case of damage caused by overheat
•
Cut off the general power switch in humid weather or left unused for long time
•
Before following operation, ensure that the alternating current wire is pull out of the power supply:
- Take off or reship any components of the equipment
- Take off or rejoin any pin or other link of the equipment
•
Do not to open the casing of the equipment
•
Do not splash any chemistry substance or liquid in the equipment or around
2
- Designated use
•
2 x Haltewinkel mit 4 Schrauben (M3 x 6 mm)
•
1 x RS232 Kabel (9-pin Stecker/Buchse, 1,35 m)
•
4 x Klebefüße
•
2 x Mounting brackets including 4 screws (M3 x 6 mm)
•
1 x RS232 cable (9 pin male to female, 1.35 m)
•
4 x Plastic cushions
- Safety instructions