Skytec 170.117 Gebrauchsanweisung Seite 5

6. CONNECTING A MICROPHONE:
a. Turn the "MASTER VOLUME" to "0".
b. Connect the microphone to the microphone cable and insert the male end into channel 1
of the mixer.
c. Depress the MIC/LINE switch – this increases the sensitivity of the input and is set for use
with a dynamic microphone.
d. Set the "TREBLE" and the "BASS" control to "0" (IN THE CENTER AT THE DETENT).
e. Set "EFFECT" to "0".
f. While talking loudly into the microphone bring up the channel volume until the red "PEAK"
indicator blinks quickly. If the indicator does not come on at all and you have turned the
channel volume to "10", then reduce the channel
volume to "7" and move on to the next step. If the "PEAK" indicator comes on at "3" for
instance, then press the MIC/LINE switch returning it to the "up" position and increase the
channel volume control.
g. Slowly bring up the "MASTER VOLUME" to the desired loudness.
* If you are using a "condenser microphone" engage the PHANTOM
POWER button.
7. CONNECTING A KEYBOARD, DRUM MACHINE, CD OR MP3 PLAYER TO THE 5/6 - 7/8 STEREO INPUT:
a. Turn down both the "Volume" control on channel "5/6" - "7/8" and the "MASTER VOLUME" control.
b. Connect the output of the device to the "5/6" input of the mixer using the appropriate input jacks. (1/4" phone or
RCA depending on the output of the device you are trying to connect)
c. If there is an output gain or volume control on the device, set that to "7". This level is a starting point but should
get you enough output to drive the input of the system.
d. Bring up the "5/6 VOLUME CONTROL" to the 5-7 range.
e. Slowly bring up the MASTER VOLUME to the desired loudness.
8. USING THE RCA OUTPUT: You can connect this output to a variety of devices like a
recording device, a powered sub-woofer, additional power amplifier and speakers or even another mixer.
a. Connect the RCA output to the input of the device into which you want to plug the mixer.
b. Set the input level of the external device according to the manufacturer instructions.
CAUTION:
• Use only this system speakers. Substituting different speakers could result in damage to the powered mixer and
could void your warranty. The powered mixer will not function with speakers that have an impedance lower
than 8 ohms.
• Do not daisy chain the speakers! No more than one 8 ohm speaker should be used on each speaker output.
• Substituting speakers may result in decreased performance.
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local
authorities or your dealer about the way to proceed.
The specifications are typical. The actual values can slightly change from one unit to the other.
Specifications can be changed without prior notice.