Pkm WKS 72B Bedienungsanleitung Seite 23

to the mains.
2. Clean the appliance thoroughly. Be very careful especially inside the appliance
(look at chapter
3. If the accessories inside the appliance are not fitted in their correct position,
replace them according to the image in chapter 4.
4. The appliance must be connected to the mains properly.
5. Allow the appliance to stabilize the temperature for approx. 24 h before use.
6. Do not overfill the appliance
Temperature setting
 Set the temperature using the ▲ and ▼ buttons by 1
0
10 C (upper compartment) or 10
 Switch on/off the internal light using the LIGHT-button.
 Select degrees Celsius or degrees Fahrenheit using the
 Flashing LCD = Setting mode of the temperature.
 Constant LCD = Cooling temperature.
Operation parameters
1. The appliance can only reach the relevant temperatures when:
a. the a ambient temperature meets the climatic class.
b. the doors close properly.
c. you do not open the doors too often or too long.
d. the door seals are in proper condition.
e. the appliance is properly positioned.
f. you have not overfilled the appliance.
g. you do not store warm or hot food in the appliance.
2. High ambient temperatures and simultaneously operating at the coldest setting
may make the compressor operate permanently to keep the temperature
constant inside the appliance.
Helpful hints/energy saving
 Try opening the door as little as possible, especially when the weather is warm
and humid. When you open the door, close it as soon as possible.
 Permanently check , if the appliance is well-ventilated. The appliance has to be
well-ventilated from all sides.
 Disconnect the appliance from the mains if you do not operate it.
 Always keep the door seals clean and in a proper condition.
CLEANING AND MAINTENANCE
0
).
0
to 18 C (lower compartment).
23
0
within a range of 5
0 0
C/ F-button
0
to