Changing The Configuration; Operating The Setup Mode - G&D DVIVision Installationshandbuch

NOTE: In addition to the configuration settings, further settings are available (see
page 35 ff.) that enable the user to adjust special system features to the characteris-
tics of the operating environment.

Changing the configuration

The configuration can either be changed in the setup mode or in the setup menu.
The descriptions of the configurable functions on the following pages include
instructions on how to configure both the setup mode and the setup menu.

Operating the setup mode

The setup mode can be enabled using the console keyboard. After enabling, the con-
figuration of the DVIVision system can be changed by using various step keys.
NOTE:
Only one setup function can be performed after the calling of the setup mode.
If you want to perform more functions, please restart the setup mode.
How to enable the setup mode:
 Press the
Hotkey+Backspace
the setup mode.
IMPORTANT: The key combination for enabling the setup mode needs to be
pressed for seven seconds.
After the first call of the setup mode, the hotkey delay can be disabled by pressing
the setup key (see page 16).
8
The successful activation of the setup mode is displayed by the blinking
control LEDs on the keyboard. Additionally, the yellow User LED will blink at
Scroll
both the computer module and the user module.
Now you can perform a setup function.
How to perform a setup function:
 After enabling the setup mode, press one of the setup keys described on the fol-
lowing pages.
How to end the setup mode without performing a function:
 Press to end the setup mode.
ESC
(default:
Ctrl+Backspace
Configuration
) key combination to enable
NUM
G&D DVIVision · 13
,  and