Quick Start P11A; Led - Adam P11A Bedienungsanleitung

2.2 Quick Start
Before connecting the loudspeakers to your audio components and the
power source make sure that both the loudspeakers and your audio system
is switched off!
a) Set all level controls fully counterclockwise.
Connect the loudspeakers with your audio units: Use a XLR cable. The male
b)
plug goes into the loudspeaker, the female plug into your audio component.
c) Check if the specified voltage matches the voltage of the power supply
you use. If this is not the case do not connect the loudspeakers to a power
source! Please contact your local dealer or national distributor.
If the voltages match, connect the loudspeaker via the included power
cables to two AC sockets.
d) Switch on your audio system. Then, switch on the main on/off switches on
the rear panel of the loudspeakers.
e) Turn on your source of music and adjust the volume carefully.

LED

There is a diode at the front, above the tweeter. When the loudspeaker is
being switched on, it will flash red a few times. This does not indicate an
overload! It signalizes the control function of the protective circuit. After-
wards, it will start to glow green, indicating power on. If the LED flashes red
during operation, this indicates an overload. The protective circuit will be
activated.
6
2.
Quick Start
Figure 1: LED
LED
Flashes a few times red when loud-
speaker is being switched on. Glows
green during operation