The Network Configuration Wizard; Scenario 1 - The Wired Connection - Noxon iRadio 400+ Bedienungsanleitung

Then, set the time format (12/24 hour).
The date and time follow. Set each of these using the navigation dial and confirm by
pressing the dial or the remote control. By the way, the date format is European – date
first, then month. Then, you can decide on a WLAN region. Unless you are currently in
Spain or France, [Most of Europe] is the correct choice for Europeans.
And that's all the information the setup wizard needs from you. It hands the baton over to
the network configuration wizard automatically.

The network configuration wizard

When switching it on for the first time, the NOXON network device does not yet have
any information about the possible network environments from which it will be getting its
content. After switching it on for the first time and selecting a language, the configuration
wizard will be displayed automatically.
As in all other menus of the NOXON, use the navigation dial to move through the selec-
tions. Confirm your selection by pressing the navigation dial.
The following chapter describes how to configure access, both for wired and wireless
network integration. If you are not satisfied with the way things are working after running
the Wizard, you can run it again by going to the main menu, selecting [Settings] and se-
lecting [Network] and then the network wizard in the following submenu.
Scenario 1 – the wired connection
If an Ethernet cable of a functioning network is plugged in at the time the device is
switched on, follow the steps below to set up the device quickly and easily:
SSID
Your WiFi network
WiFi network of your neigh...
[Rescan]
[Wired]
[Manual config]
ets arrive in the right place. Normally, that's all there is to it, and the connection is made.
In rare cases, however, static IP addresses are assigned for certain access settings—for
more information, have a word with your network administrator. See "Sometimes re-
quired: a fixed IP.
If a DHCP server is active in your router – which is
the case in almost every current model – please
select [Wired].
The wizard now automatically connects to your
router and gets its network address from the
DHCP server. Every device in the network must
have such an identifier to ensure that the IP pack-
67