VINCENT PHO-8 Bedienungsanleitung Seite 23

SETTING THE TYPE OF THE PICKUP SYSTEM
Depending on the construction principle of the record player pickup system the PHO-8 must be adjusted
to the correct operating mode using the switch "MC/MM" (3). The two pickup types that are used in most
cases are named "MM" (moving magnet) and "MC" (moving coil). All information you need should be
written in the pickup system data sheet or the record player user manual. In case of doubt ask your local
HiFi specialist.
If your record player is equipped with an MC system that is no "high output MC system", the mode switch
"MC/MM" (3) must be set to "MC". Any additional adaption to the pickup system is not possible.
High output MC systems are MC systems with a nominal output voltage of more than 1.5 mV.
If your record player is equipped with an MM system or a "high output MC system", the mode switch
"MC/MM" (3) must be set to "MM". Any additional adaption to the pickup system is not possible.
If your record player is equipped with a crystal pickup system or if it contains a phono pream-
plifier then the record player must be connected to the amplifier's line level input directly and an
external phono preamplifier is not necessary.
Your local HiFi specialist will assist you if there is any help needed. He will set up your record player if
you let him.
Vincent
23