Clatronic CTV 792 Bedienungsanleitung Seite 59

Analogue Output Setup
Dolby Digital Setup
05_CTV792_GB 59
Screen saver
The player is able to display a still image for any time on the screen. This can
cause damage to the screen. It is therefore recommended to activate the screen
saver.
The following options are available:
On: The screen saver is activated (default setting).
Off: The screen saver is deactivated.
Downmix
Change the characteristics of the speaker output:
LT/RT: Choose this setting if you want to play the DVD with the Pro Logic
Dolby stereo effect. This produces a almost real 2-channel replay effect.
Stereo: Choose this setting if you want to play a DVD, that has been produ-
ced in the 5.1-Audio format, as 2-channel stereo sound.
3D SURROUND: You may probably not have a 5.1-Audio system. In this case
you can use the „3D SURROUND"-setting to simulate a similar sound effect.
Off: Select this setting to transmit the Audio signal to the output device
without changes.
Dual Mono
The Audio output is normally in stereo. Here you have the possibility to choose
Mono-output instead of Stereo-output.
Stereo: The Audio output is in Stereo (default).
L-Mono: The Audio output is in Mono. In this case the signal of the „left"
stereo channel is transmitted to all speakers.
R-Mono: The Audio output is in Mono. In this case the signal of the „right"
stereo channel is transmitted to all speakers.
Mix Mono: The Audio output is in Mono. In this case the signal of the „both"
stereo channel is transmitted to all speakers.
Dynamic
The term „Dynamic" (Dynamic Range) describes the ratio of quietest and loudest
sound. If the dynamic range is very large, you will experience very quiet and very
loud sounds.
This may cause replay problems. Let us assume that you are watching a DVD in
a relatively loud environment. You can now increase the volume to be able to hear
also the very quiet passages, however with the disadvantage that loud passages
will be unacceptably loud. In this case it would make sense to compress the
dynamic range (i.e. reduce) and increase the output volume at the same time.
FULL -1/8: The dynamic range is compressed slightly (1/8) to full (FULL).
OFF: The dynamic range is not compressed at all (default).
59
26.03.2008, 15:06:13 Uhr