Stand Alone Operation; Recording Scenes - Kapego 861203 Bedienungsanleitung

Manual
Article No.: 861203

6.2. Stand Alone Operation

When dip-switch 10 is flipped to „OFF" position, the Stand Alone mode is enabled. Every X-Fade-6
Pro outputs the DMX data of 512 channels.

6.3. Recording Scenes

6.3.1. Recording Scenes Mode enables: press and hold down the „O/P" button for
approximately 3 seconds until the LED indicator next to the „O/P" button flashes with red.
Now Record mode is engaged and you may release the „O/P" button.
6.3.2. If the selected scene has been stored before, its indicator will be on. Press and hold the
„Scene" button down for about 2 seconds and all LED indicators will flash repeatedly 3
times to delete it.
6.3.3. Select the „Scene" button where you wish to record to. The selected „Scene" LED will
flash repeatedly.
6.3.4. Adjust the corresponding „Channel Fader" all ways up to ten(10) to set the desired fader
level for the step of the scene. Once you're satisfied with the setting, press the „Scene"
button to save it. All LED indicators will flash repeatedly 3 times, indicating that the step
of the scene has been recorded.
6.3.5. Repeat Step 6.3.4. to record more steps for the scene, up to 100 Steps can be created
per scene.
6.3.6. To record additional scenes, repeat Step 6.3.3 - 6.3..5.
6.3.7. Once you've stored all of your scenes, press and hold the „O/P" button to exit. A blue
LED next to the „O/P" button comingon is indicative that you are out of the Recording
Scene mode.
NOTE:
If 2 continuous steps have the same data, they will merge into one step automatically. The fadetime
now is two times long as before merged. In Online Mode, users can input external DMX data to
create Scenes.
7