Mains Connection; Operation - mivoc SW 1500A-II Bedienungsanleitung

Connect the connections LINE INPUT
with the subwoofer output or a volume-
controlled pre-amplifier output of your
amplifier.
For this, use the shielded cinch cables.
Connection example:

Mains connection:

Make sure that the operating mode switch (4) is switched off
(position "OFF") before you connect the active subwoofers to the
power supply grid.
Insert the connecting plug of the mains
cable into the mains connection (8) Insert
the mains plug into a mains socket.
The device is switched off or the auto-
matic switch activated using the operat-
ing mode switch (4).
22
Connect the connection LINE INPUT
R (1) with the right output and the con-
nection LINE INPUT L (2) with the left
output.
Position "OFF". Device is switched off.
Position "AUTO". The device switches
on automatically when a signal is pend-
ing on the connection LINE INPUT (1
and 2).
The active subwoofer switches off auto-
matically after approx. 10 min without a
signal at the input.

Operation

After you have made all the connections and checked everything again, your active
subwoofer is ready for use.
Turn the control SUBWOOFER LEVEL
(5) back completely.
Move the control LOW PASS FRE-
QUENCY (7) to the central position.
Set the PHASE switch (6) to the "0"
position,
Set the desired operating mode using
the operating mode switch (4).
Switch on the connected amplifier and
start the playback.
Adapt the subwoofer volume to the oth-
er loudspeakers using the SUB-
WOOFER LEVEL (5) control.
Adapt the insulating frequency to the
other loudspeakers using the control
SLOW-PASS FREQUENCY (7).
Position "ON". Device is switched on
permanently.
When the device is switched on, the
operating display LED (3) lights up
green, when the device is switched off, it
lights up red.Apart from this, the brand
logo lights up on the front when the
device is switched on.
Position "0"
For a description of the various operat-
ing modes, see "mains connection".
Set a medium volume on the amplifier.
The subwoofer should not be able to be
heard acoustically above everything
else. No buzzing noise should occur.
The subwoofer should complement the
existing loudspeakers in the deep bass
range. Adjust the insulating frequency
as deep as possible, however without
creating forcing or "holes" in the fre-
quency band.
It is possible that the SUBWOOFER
LEVEL (5) has to be readjusted after
that.
23