Gastroback DESIGN STABMIXER ADVANCED PRO E 40976 Bedienungsanleitung Seite 35

pressing the ON-button, immerse the processing tool in the food (up to the half of its
height at most), to avoid excessive splashing and dripping of liquids onto the appli-
ance.
1. Prepare your food and fill it into a sufficiently large and high-sided vessel (like the
vessel provided).
WARNING: The provided vessel is not heat resistant. The max. temperature is
70 degrees. Let the boiling food cool down a little bit before starting to blend. The
whisk holder is not dishwasher safe!
2. Ensure, that the appliance is unplugged.
3. Place the shaft of the stainless steel whisk into the whisk holder. Place the whisk
holder onto the motor block and press together until it snaps into place. There
may be no gap between the motor housing and the stainless steel whisk. The
whisk holder must be locked firmly and may not wobble.
4. Immerse the stainless steel whisk into the food. Choose the speed with the vari-
able control switch. It is to be expected, that the food will splash during operati-
on. When processing hot meals, do not hold the appliance in the rising steam to
avoid condensation on the motor housing. Immediately wipe off condensate on
the motor housing. The lower part of the stainless steel whisk should be always
covered with food to avoid splashing.
5. Connect the power plug to a suitable wall power outlet.
6. Hold on to the vessel with one hand and press the ON-button to start the motor.
Slowly circle the appliance during operation. Hold the appliance upright in the
mixing vessel during operation to avoid splashing.
CAUTION:
Do not use the appliance with the stainless steel whisk in continuous
operation for more than 2 minutes to avoid overheating. If processing large quantities
of food, regularly interrupt the operation and unplug the appliance for a few minutes,
allow the motor to cool down.
7. Blend your food to the desired quality but at least after 2 minutes of continuous
operation release the ON-button.
8. Wait until the motor stops, before you lift the whisk out of the food.
9. Always unplug the appliance immediately after operation. Lay down the appli-
ance on a stable, dry and clean surface, where it cannot fall.
WARNING:
ly and unplug the appliance before assembling or dismantling the tools.
Always release the ON-button, wait until the motor stops complete-
35