B) Thorough Cleaning Of The Blending Container; C) Cleaning Of The Motor Unit; Disposal - Renkforce 1301269 Bedienungsanleitung

b) Thorough Cleaning of the Blending Container

• Disconnect the closure cap (1) from the lid (2), by turning the closure cap counter-clockwise and remo-
ving it.
• Screw the screw ring (7) from the mixing container and remove the blade guide (6) and sealing ring (5).
The circlip (4) cannot be removed for reasons of safety.
• Flush all components (1-7) clean and dry them.
The components are not suitable for cleaning in a dishwasher.
• Put the sealing ring (5) onto the blade guide (6) from the top and reattach this unit to the bottom of the
blending container (3) with the screw ring (7).
Observe correct positioning of the sealing ring (5), since the blending container may leak other-
wise.
• Insert the closure cap (1) with the two latching tabs into the cut-out of the lid (2) and turn it clockwise
until it is fastened.
• Put the lid (2) back onto the blending container (3).
• Put the complete blending container (3) back on the motor unit (8).

c) Cleaning of the Motor Unit

• Only clean the motor unit (8) with a slightly moistened soft cloth.
• Never use any aggressive cleaning agents or chemical solutions for this, as these may damage the
surface of the casing.

14. Disposal

Electronic devices are recyclable waste and must not be disposed of in the household waste!
Dispose of the product according to the applicable statutory provisions at the end of its service
life.
24