Power Dynamics PDC-10 Gebrauchsanleitung Seite 6

TOP PANEL FEATURES :
1. PLAY / PAUSE - Begins or pauses playback of the track. If the track is paused the cue point is set
at that point.
2. CUE – Press CUE and the track will return to the cue point and pauses there (if you do not have set
the cue point with the PLAY / PAUSE button, the beginning of the track is the cue point.) If the track is
on the cue point you can play again by holding down the CUE button. If CUE has been released the
track jumps back to the cue point and pauses. When PLAY / PAUSE is pressed while holding CUE
and then releases both buttons, the track will be play back again.
3. PITCH - / + - The playback speed is reduced / increased. If the key is released, the controller
returns to its original playback speed. The beats of two tracks can easily be matched with this function
in combination with point 14.
4. JOG WHEEL - Scratching or track Searching Mode with SCRATCH / SEARCH button (12).
Scratch Mode: When the LED is lit, moving the Jogwheel, you can scratch the track. Consider moving
the platter of a turntable with a vinyl on it.
Search Mode: When the LED is not lit in Pause mode moving the Jogwheel, the unit will search
through a track for a desired frame. In Play mode, the speed changes when the Jogwheel is turned.
Turning faster/slower will speed up/down the play back speed. If the key is released, the controller will
return in its original speed. The beats of two tracks can easily be matched with this function in
combination with point 14.
5. LOAD - Using this button, a selected track will be loaded to the controller.
6. BROWSE – Turn this knob to scroll through the music of the software. To open a folder or a
"higher" folder in the software push on the button.
7. TREBLE - Controller to adjust the treble.
8. FOLDER OUT - To navigate through folders in CD or USB mode.
9. BASS - Controller for adjusting the bass.
10. VOLUME - Controller to adjust the volume of the music.
11. MASTER VOLUME - Controller for the total volume of both units. The volume of one unit should
be regulated with volume control (10).
12. SCRATCH / SEARCH - See a part of point 4.
13. REV - Plays the track backwards.
14. SYNC - The rhythm of one unit can be matched with the rhythm of the other unit. See also point 3.
15. CROSSFADER – The way you want tracks of both units mixed should be realized with this fader.