Mounting the Hook-and-Loop Tape
1
Remove self-adhesive ba-
cking of the hook-and-loop
tape.
2
Place the self-adhesive
back onto a plane surface of
the vehicle or onto the
mounting plate.
Apply firm pressure for 10 to
15 seconds for a sure adhe-
sion.
NOTICE
The adhesive mounting is fully loadable after approx. 36 hours.
3
Mount handset with the hook-and-loop tape on its backside onto
the mounted hook-and-loop tape.
28
1
3
2
Functional Test
After installation, reconnect vehicle battery.
Test function of the Dräger Interlock
tions for use.
Installation Certificate
After installation, complete the installation certificate contained in
the instructions for use.
Instrument Setting and Calibration
This work may only be carried out by an authorised Dräger Interlock
Service Center.
If required, set the variable instrument settings of the
®
Dräger Interlock
XT.
Calibrate the Dräger Interlock
®
XT according to the instruc-
®
XT, if neccessary.
®