Rear Panel - Pioneer U-05-S Kurzanleitung

Connections

Rear panel

Caution
• When making or changing connections, be sure to
turn off the power switch and disconnect the power cord
from its AC power outlet.
• Do not connect the power cord until all component and
device connections are completed.
AES/EBU input connector
This digital input supports AES/EBU
signals in PCM format (up to 192
kHz/24 bits).
DIGITAL IN connectors
These connectors support PCM format
signals (up to 192 kHz/24 bits).
ANALOG LINE OUT connectors
These two output connectors (RCA/
XLR) simultaneously generate signals
selected with the INPUT knob.
Signals are output when "LINE" is
selected with the OUTPUT knob.
Balanced output connector (appearance on unit
side; equivalent to XLR-3-31)
1 GND
1
2 2 HOT
3 COLD
3
If a power amplifier is connected,
when selector switch 1 is set for
linked volume (VARIABLE), sound
volume can be controlled by the
Pre-main amplifier, etc., furnished
unit.
with balanced-type input connectors
2
Connections to components furnished with digital output.
AES/EBU OUT COAXIAL OUT
Coaxial digital
Digital balanced
cable (75 Ω)
cable (110 Ω)
Balanced cable
R
OPTICAL OUT
USB
Optical digital USB cable
cable
Selector switch 1
Either set the analog output
connector's output level to fixed (FIX),
or volume-linked (VARIABLE).
L R L
Pre-main amplifier with RCA (pin plug)
input connectors
Computer with USB port
Note
• A dedicated driver may have to be installed in your
computer (see "Install the driver" of the operating
instructions).
A type
USB input connector (B type)
Supports PCM format signals (to 384kHz/32 bits),
and DSD format (to 5.6 MHz).
Selector switch 2
Use to switch the phase of the analog
output.
Note:
XLR and RCA signals are switched
together.
To AC outlet
Power cord (accessory)