Switching The Operation Mode; Use And Care Of The Remote Control; Installing The Battery - Pioneer GEX-P5700TVP Bedienungsanleitung

Section
02 Before You Start
The microprocessor must be reset under the
following conditions:
! Prior to using this unit for the first time
after installation
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
! When setting the position of the operation
mode switch on this unit
% Press RESET with a pen tip or other
pointed instrument.
RESET button
Note
If you reset the microprocessor, memorized
broadcast stations and other information is
erased, and this unit returns to its initial
settings.

Switching the operation mode

This unit features three operation modes:
SRC : OSD OFF mode, SRC : OSD ON mode
and STAND ALONE mode. Switch the mode
according to the combined components.
SRC : OSD OFF mode
! Using with a Pioneer head unit featuring
an IP-BUS input.
! Not using this units OSD (On Screen Dis-
play) indications in the display.
6
En
SRC : OSD ON mode
! Using with a Pioneer head unit featuring
an IP-BUS input.
! Using this units OSD (On Screen Display)
indications in the display.
STAND ALONE mode
! Using with a display featuring RCA video
input.
% Use a thin standard tip screwdriver to
switch the operation mode switch.
! After switching, reset the micro-
processor.
Use and care of the remote
control

Installing the battery

Slide the tray out on the back of the remote
control and insert the battery with the plus (+)
and minus () poles pointing in the proper di-
rection.