Philips HD7860 Anleitung Seite 4

Problem Solution
The light in the You have not yet flushed the machine. See chapter 'Preparing
on/off button the machine for use'.
continues to flash
slowly.
You have used the SENSEO
higher than 2200 metres above sea level. This has caused the
water in the machine to start boiling before it has reached
the required temperature, which prevents the machine from
functioning properly. Switch off the machine and no longer
use it at altitudes higher than 2200 metres above sea level.
The light in the Make sure that:
on/off button
continues to flash
rapidly.
the water reservoir is placed properly;
there is enough water in the water reservoir (i.e. above the
q MIN level if you want to brew 1 cup);
the ambient temperature is not lower than 10°C. If it is, the
machine does not function properly.
When I push one Make sure you have inserted the plug properly into the wall
of the buttons, socket. Also make sure you have closed the lid and locked the
nothing happens. lid lever. If the lid is not closed or the lid lever is not pushed
until it locks with a click, the machine does not work.
Water leaks from You may have filled the water reservoir beyond the MAX
the machine. level. Never fill the water reservoir beyond this level.
Perhaps the sieve in the centre of the pod holder is clogged.
If it is, unclog the sieve by holding the pod holder under a
running tap. If necessary, use a washing-up brush or a pin to
unclog the sieve.A
Check if the coffee pod is placed properly in the centre of
the pod holder.
Check if the sealing ring is not stuck under the edge of the
water distribution disc (see drawing at the beginning of this
user manual).
It is perfectly normal for some drops of water to spill onto
the worktop. This may happen, for instance, when you place
or remove the water reservoir. Be careful when you remove
used coffee pods, for there may still be some water on the
pods.
Perhaps you removed the water reservoir when the coffee
machine was heating up. This may cause some water to leak
out of the machine (this water normally ends up in the water
reservoir).
If none of the above solutions solve the problem, contact the
Philips Consumer Care Centre in your country.
I cannot open A vacuum may have temporarily formed under the lid.
the lid.
Switch off the machine. Pull up the lever as far as it goes and
wait 24 hours before you open the lid. This requires quite
some force.
Make sure that the sieve in the centre of the pod holder is
not clogged. If it is, unclog the sieve by holding the pod holder
under a running tap. If necessary, use a washing-up brush or a
pin to unclog the sieve.
Make sure you do not move the SENSEO
Moving the machine, placing it outdoors or in a cool or cold
environment does not accelerate the unlocking of the lid.
Do NOT put the SENSEO
as this does not accelerate the unlocking of the lid.
If problems continue to occur, contact the Philips Consumer
Care Centre in your country.
The machine Perhaps the sieve in the centre of the pod holder is clogged.
produces less If it is, unclog the sieve by holding the pod holder under a
coffee than before. running tap. If necessary, use a washing-up brush or a pin to
unclog the sieve.
Descale the machine (see chapter 'Descaling').
4222.200.0182.2
® coffee machine at an altitude
® machine.
® machine in the fridge or freezer,
Problem Solution
The SENSEO ® You have not flushed the machine properly before first use.
coffee machine As a result, the boiler is not or only partly filled. Flush the
brews only a small machine properly (see chapter 'Preparing the machine for
quantity of coffee use') before you brew another cup of coffee.
or no coffee at all
when I use it for
the first time.
I cannot close the Check if a used coffee pod sticks to the water distribution
lid properly. disc. If this is the case, remove the used pod.
Check if you have not put two coffee pods in the 1-cup pod
holder q.
The machine has Contact the Philips Consumer Care Centre in your country.
been stored in a
room that was not
frost-free.
The SENSEO® Make sure that:
coffee is not
strong enough.
you have used the correct number of pods and have pressed
the right button. Use 1 pod in combination with the 1-cup
pod holder q and the 1-cup button q. Use 2 pods in
combination with the 2-cup pod holder qq and the 2-cup
button qq;
the coffee pod or pods has/have been placed properly in the
centre of the pod holder, to prevent water from escaping
along de edge of the pod or pods. When you use two coffee
pods on top of each other, make sure that the convex sides
of both pods point downwards and press the pods lightly into
the pod holder (see step 6 in chapter 'Using the machine');
you have not used the same pod twice by accident;
the coffee in the pod is evenly distributed;
If you prefer a more robust flavour, SENSEO
with a stronger blend are available.
The SENSEO ® If you prefer a milder flavour, SENSEO
coffee is too milder blend are available.
strong.
The coffee is not Do not use cups that are too large, as they cause the coffee
hot enough. to get cold more quickly. When you use cups, make sure they
have a capacity of 150ml. When you use a mug, make sure it
has a capacity of 280ml.
To keep the coffee hot longer, preheat the cups with hot
water.
The machine Move the drip tray to a higher position so that the edge of
spatters when I your cup is closer to the spout.
brew coffee.
I want to brew If you remove the drip tray, the mug may fit under the spout.
coffee in a tall
vacuum mug but
this mug does
not fit under the
spout.
Water and steam Your SENSEO
have leaked from drained all water for safety reasons. The machine is blocked
the bottom of the and does not function anymore. For assistance, please visit
appliance in a fast our website www.senseo.com or take the machine to a
way. Philips service centre.
® coffee pods
® coffee pods with a
® machine has a technical malfunction and has
4/8